SkyRC B6DC charger LiPo 1-6s 5A 50W

Model: SK-100002
Manufactured by: SkyRC

38.61EUR

Sold Out


Description 
The SKYRC B6 DC is a high-performance microprocessor control charger / discharger with battery management for use with all common battery types. With integrated equalizer for 6 cells LiPo, LiFe and lithium-ion batteries (LiIon). It has a maximum of 5A charging current at max. 50W and can be powered by a 12 volt car battery. 
 
Optimized operating software
The SKYRC B6 DC has the so-called AUTO function, which monitors the supply of the current during the charging or discharging process. Especially important for lithium batteries, to prevent overcharging and possible explosion due to user misuse. It can automatically disconnect the circuit and trigger an alarm in the event of a malfunction. All programs of this device are monitored by a two-way connection and the internal communication for maximum safety and to minimize problems. All settings can be configured by the user!
 
Internal Independent Lithium Battery Balancer
The SKYRC B6 DC0 uses individual cell voltage compensation. It is not necessary to connect an external balancer for charging in balancer mode.
 
Balancing individual cells during discharge
During the process of discharge, the SKYRC B6 DC can monitor this and balance each cell of the battery individually. If the voltage of a single cell is abnormal, an error message will be displayed and the process automatically terminated.
 
Adaptable to various types of lithium batteries
The SKYRC B6 DC can be adapted to the different types of lithium batteries such as lithium-ion, LiPo and the new LiFe batteries.
 
BONUS FAST and STORAGE Mode for Lithium Batteries
At Fast, you reduce the amount of time the battery keeps its capacity, while STORAGE increases the amount of time the battery keeps its capacity. For example, the batteries can be stored longer without risk.
 
Maximum safety
Delta-Peak Sensitivity: The automatic termination of the charging process is based on the principle of DeltaPeak voltage detection. If the battery voltage exceeds the threshold, the charging will automatically stop.
 
Capacity limit
The charging capacity is always calculated from the multiplication of the charging current and the time. If the charge capacity exceeds the limit, the process automatically stops, but only if a maximum value is set.
 
Temperature Threshold *
The internal chemical reaction of the batteries causes the temperature of the batteries to rise during charging and discharging. When the previously set temperature is reached, the charging process is terminated. 
* This function is available only by connecting the optional temperature sensor.
 
Processing time
limit : You can also limit the maximum process time to avoid any possible defect.
 
Save / load
data The data of a maximum of ten batteries can be stored. You can access this data at any time without special program settings.
 
Cyclic Charging / Discharging
1 to 5 cycles of the dynamic process Charging> Unloading or Unloading> Charges can be performed to reactivate individual cells or to align.
 
Technical specifications
Input voltage: DC 11-18 volts
Charging power: Max. Power 50W
Max. Discharge capacity: 5W
Charging current: 0.1-5.0A
Discharge current: 0.1-1.0A
Balancer current max .: 300mA / cell
NiCd / NiMH: 1-15 cells
Li-ion / Fe / polymer: 1-6 cells
Pb battery voltage: 2-20V
Weight: 277g
Dimensions: 133x87x33mm